The Innovative Pigging Specialists

We know your objectives…
We understand your challenges…

…so we can help you better!

People, Equipment,
and Expertise


We’ve delivered more than 500 operationally superior projects…

From simple cleaning jobs to complex, high-tech in-line inspection campaigns


I am an integrity inspector with Inter Pipeline, and have used Marler to provide ILI support services for the past 5 years, and am extremely pleased with the quality they were able to provide.

Derek Hayton
Integrity Inspector
Inter Pipeline

Difficult? Torturous? Downright Unpiggable?

Put us to work on your challenges
Contact us for an expert overview of your available options


Safety is Number One

Our number one priority is to ensure the safety of our staff and yours.

We have an aggressive safety and training program to make sure our staff are using both the best practices and equipment for the task at hand.

Certifications

FAQ

What is Tool Tracking?

Tool tracking is where a tracker or team of trackers follow a cleaning, gauge or smart tool from launch to receive.
The trackers use AGM’s, geophones, and transmitter/receivers to understand the position of the pig in the line. The information is shared with the pipeline operator.

What is an AGM?

An AGM is an “above ground marker”. It is an electronic device that very accurately detects the passage of a pipeline tool. It can be triggered with either a transmitter signal, or magnetic field on an MFL (magnetic flux leakage) tool.
When used in conjunction with a smart tool, the AGM’s are placed very accurately in surveyed locations, and the data of the tool passage is used to “map” the line geographically.

Why do tools need to be tracked?

Tools need to be tracked so the pipeline operator knows if the tool is continuing to move through the pipeline without issue.
Additionally, the tool may be tracked with AGM’s at surveyed sites in conjunction with an in-line inspection with a smart tool, to tie in geographical data.

Why is the AGM survey accuracy important?

The more accurately the locations for AGM’s are surveyed, the more accurate the data tied to a smart tool run becomes. This allows the operator to accurately pinpoint dig locations for defect verification and remediation.

Can you safely do liquid cleaning in gas pipelines?

Marler has developed a safe and efficient method for introducing liquids into a gas pipeline for the purpose of cleaning the line. Please reach out to us through the website, or give us a call to discuss.

How important is cleaning before inspection runs?

Smart tools, sometimes called intelligent tools, require differing levels of pipeline cleanliness. For instance, MFL (magnetic flux leakage) tools require less cleaning than a UT (Ultrasonic) tool, however, with the MFL tool, you must ensure there is little or no ferrous material in the line, where the main concern for UT is eliminating as much, if not all debris in the line. Marler understands the difference in levels of cleanliness, and type of cleaning required for the various types of In-Line Inspection tools.

Are there special design requirements for barrels used with smart tools?

Yes. Smart tools are considerably longer than cleaning and gauge tools, and therefore require longer oversize barrels at launch, and a nominal that is equal or greater than the length of the smart tool at receive.

Does piping for temporary use have the same engineering requirements as permanent piping?

Yes. Temporary piping must be engineered to the same standard as permanent piping.